Gain Level - HOBBYEAGLE A3 PRO V2 User Manual

HOVER mode. The procedure is quite similar to that of level calibration. The only difference is in the first
step. Before calibrating, you need to lift the airplane and make it vertical to the ground instead of putting
it on the ground.
Short press the button when LED is flashing 6 times in the Setup Menu, then LED will start blink Blue
rapidly for several seconds, do not move the airplane and keep its attitude until the calibration is done.
7. MAXIMUM ANGLE
This function is used to setup the maximum allowed tilt angle
of the airplane for ANGLE mode.
After entering in this function, the color of LED shows you the
angle currently selected. The default setting is ± 60deg
(Green), each short press of the button will switch to the next
value. After you finish making your selection, just wait for 5
seconds until LED starts blink quickly which indicates that the modified is saved and then you will be
brought back to the Setup Menu level automatically.
If you do not want to change anything, just wait for timeout without any operation.
8. Servo Frequency
This function is used to set the working frequency of the servos.
The analog servos can only work with 50Hz. If you do not know
what the maximum update rate that is tolerated by your servos
never use more that 50Hz. The higher the frequency the better
it is for the flight performance of the gyro but you must check
the servo specifications before increasing the setting.
Otherwise, the servos may get damaged!
After entering in this function, the color of LED shows you the
frequency currently selected. The default setting is 50Hz (Red),
each short press of the button will switch to the next value. After
you finish making your selection, just wait for 5 seconds until LED starts blink quickly which indicates that
the modified is saved and then you will be brought back to the Setup Menu level automatically.
If you do not want to change anything, just wait for timeout without any operation.

9. Gain Level

This function is used to change the level of the basic gain. After
entering in this function, the color of LED shows you the gain
level currently selected. The default setting is Medium (Green),
each short press of the button will switch between Small,
Medium and Large. After you finish making your selection, just
wait for 5 seconds until LED starts blink quickly which indicates
that the modified is saved and then you will be brought back to
WWW.HOBBYEAGLE.COM
LED Color Description
Solid Red
±30°
Solid Green
±60°(default)
Solid Blue
±90°
LED Color Description
Solid Red 50Hz (default)
Solid Green 65Hz
Solid Blue 165Hz
Solid Yellow 200Hz
Solid White 270Hz
Solid Violet 333Hz
LED Color Description
Solid Red Small
Solid Green Medium (default)
Solid Blue Large
12 / 15