HOBBYEAGLE A3 PRO V2 User Manual page 10

To get out of the Position Selection Menu just keep the button pressed (2 seconds) again until LED starts
flashing Blue quickly, then you will be brought back to the Setup Menu.
4. Gyro Direction
Here you can reverse the gyro direction for Aileron, Elevator
and Rudder. Short press the button when LED is flashing 4
times in the Setup Menu to get into the Channel Selection
Menu. In this second-level menu, LED will flash Blue several
times every 3 seconds in a loop and the number of times LED
flashes shows at which channel you are currently. For example, one Blue flashing means "Aileron", after
waiting about 3 seconds, a twice Blue flashing means "Elevator", and so on.
When you reach the channel that you wish to set, short press the button to get into it. After entering in
the color of LED shows you the direction currently selected for this channel. Each short press of the
button will switch between Normal and Reversed. After you finish making your selection, just wait for 5
seconds until LED starts blink quickly which indicates that the modified is saved and then you will be
brought back to the Channel Selection Menu level automatically.
To get out of the Channel Selection Menu just keep the button pressed (2 seconds) again until LED starts
flashing Blue quickly, then you will be brought back to the Setup Menu.
VERY IMPORTANT!
It is extremely important to make sure that the gyro reacts in the correct direction for each channel
before flight. An opposite reaction of the gyro could lead to losing control or even crash!
Check the gyro direction for Aileron
Quickly move the right wing downward around the roll axis, the right aileron surface should flap down and
the left flap up as shown below.
Check the gyro direction for Elevator
Quickly move the nose of the airplane downward around the pitch axis, the elevator surface should flap
WWW.HOBBYEAGLE.COM
LED Color Description
Solid Red Normal (default)
Solid Green Reversed
10 / 15