Cleaning And Care - Beem CJ-710E Manual

EN
10. Transfer the heated milk or the milk froth to a suitable vessel.
a After the end of the "WARM" and "HEISS (HOT)" programmes, the heated milk
can easily be poured into a suitable vessel through the lid opening, just like a
normal pouring spout.
b After the end of the "KALT (COLD)" and "SCHAUM (FOAM)" programmes, the
milk can likewise be poured through the lid opening into a suitable vessel. Then
take off the lid and remove the milk froth using a spoon or similar implement.

Cleaning and Care

NOTES
• Before commencing the cleaning, note the safety instructions in the
"Safety Instructions" chapter!
• Clean the device after each use to prevent the formation of germs.
• Do not use any toxic, corrosive or abrasive cleaning agents or scouring
sponges to clean the device. These can damage the surface.
1. Empty the milk container (6) if necessary.
2. Wipe down the base station (3) with a damp cloth. If necessary, use a little mild
detergent to remove more intense soiling.
3. Clean the milk container and the lid (1) with warm water and mild detergent, or in the
dishwasher.
IMPORTANT! The stirring insert (8) must not be cleaned in the dishwasher! Only rinse
this off by hand. For more thorough cleaning, detach the ring from the stirring insert if
necessary.
4. Dry all parts properly before the device is reassembled and / or stored away.
5. Check the mains cable regularly for any damage.
Storage
Store the device and all accessories in a dry, clean, frost-free place that is protected from
direct sunlight and cannot be accessed by children or animals.
05119_DE-EN-FR-NL_A5_V2.indb 24 05119_DE-EN-FR-NL_A5_V2.indb 24
24
13.11.2017 11:43:51 13.11.2017 11:43:51