Cleaning And Care - Beem SB-012 Manual

EN
1. Take the lid (1) off the milk jug (6).
2. Depending on the programme, place the frothing spiral (8) or the stirring insert (9) on the
magnetic pin on the bottom of the milk jug (Picture C) (see the "Preparation and Operation"
chapter – "Programme Selection").
3. Fill the milk jug with the appropriate amount of milk depending on the programme. Note the
maximum fi ll levels (see the "Preparation and Operation" chapter – "Markings in the Milk Jug").
4. Place the lid on the milk jug and press it down as far as it will go.
5. Place the fi lled milk jug into the base station (3).
6. Set the programme you want by pressing the On / Off button (4). The LED ring (5) indicates
the selected programme by fl ashing in the corresponding colour (see the "Preparation and
Operation" chapter – "Programme Selection").
The programme then starts automatically. During the programme sequence, the LED ring
lights up constantly in the colour of the set
At the end of the programme you will hear fi ve beeps and the LED ring goes out. The device
switches off automatically.
The programme sequence can be aborted at any time by pressing the On / Off button.
7. Pull the mains plug out of the plug socket after use. The LED ring lights up in all colours (red,
white, blue) and goes out again.

Cleaning and Care

PLEASE NOTE!
• Do not use any toxic, corrosive or abrasive cleaning agents or scouring sponges to clean
the device. These may damage the surface.
• Check the connecting cable regularly for any damage.
1. If necessary, empty the milk jug (6).
2. Wipe down the base station (3) with a damp cloth. If necessary, use a little detergent to
remove more intense soiling.
3. Clean the milk jug and the lid (1) with warm water and detergent or in the dishwasher.
Please Note: However, regular cleaning in the dishwasher may have a detrimental effect on
fi ttings. We therefore recommend cleaning by hand.
IMPORTANT! The frothing spiral (8) and the stirring insert (9) must not be cleaned in the
dishwasher! Only rinse them by hand. For more thorough cleaning of the frothing spiral, you
can remove the ring.
4. Dry all parts well before you reassemble and / or store away the device.
programme.
20