Memory Mode Test (1653B And 1654B Only) - Fluke 1652C Calibration Manual

Memory Mode Test (1653B and 1654B Only)

Use the following test to verify the proper function of the UUT Memory Mode:
1. Turn the rotary switch to V.
2. Connect the PE and L input jacks of the Tester to the 5320A V, HIΩ, mA~ Output
terminals as shown in Figure 4.
3. Set the 5320A for the Volts function and apply 25 V, 50 Hz to the Tester.
4. Press UUT
5. Use and the to set the data identity.
6. Press to save the data.
To recall the saved data:
7. Press
8. Use and to set the data identity.
9. Press twice to recall the data. The recalled data should match the saved value.
Figure 4. Touch Pad Sense Test
to enter Memory Mode.
to re-enter Memory Mode.
PE
(L2/Green)
L
(L1/Red)
Electrical Installation Tester
Performance Tests
Fluke 5320A
5320A MU LTIFUNCTION ELECTRICAL
OUTPUT
V , HI , mA LO LO - SENSE
HI
HI
50V PK
MAX
1500V PK
MAX
LO
LO
20V PK
20V PK
Z , Z GND , RCD
L
L PE N
L1 H L2 E L3 S
280V 280V
RMS RMS
MAX MAX
20V PK
METER
INPUT
METER
A COM V
C AT I
30A 1000V
RMS C AT II
20V PK
600V
MAX
RMS MAX
gad002.eps
21