Trouble Shooting - Dexter Laundry 20VCIS2 Manual

7. TROUBLE SHOOTING

Problems Probable causes
The battery is less
power.
The charger is
Device doesn't
broken.
start.
On/off switch may
be defective.
Engine faulty.
Device operates
The battery is less
sporadically or
power.
at low power.
Worn or cracked
Carbon Brushes.
Dirty Blade.
Wood burns at
Material is
ends when cut.
binding.
Finished side is
down.
Blade chipped or
Material frays or dull.
chips out.
Blade
inappropriate
for material.
Material is
unsupported.
Corrective action
Check the battery and charge it.
Repair by customer care.
Check the battery and charge it.
Check Carbon Brushes.
Replace if damaged or worn.
Clean Blade using blade cleaner or mineral spirits.
Check position of work material on Table. Material must
be flat, flush against
Fence and supported on ends.
Keep finished side of material up or facing operator.
Bottom and back side are prone to chip out.
Check for damaged teeth.
Sharpen or replace blade.
Check blade manufacturer's recommendations for
material being cut. For cross cutting hard wood and
for precision cuts use a thin kerf blade with 60 or more
teeth.
Use a thin piece of scrap material, such as 1/4" plywood,
underneath or behind the material to support the edges
of the material as it is being cut.
FR FR
ES ES
PT PT
IT IT
EL EL
PL PL
RU RU
UA KZ
KZ UA
RO RO
BR BR
EN
EN
371