Dexter Laundry 20VCIS2 Manual page 370

5. OPERATION
Guide the saw along the edge to achieve a straight rip cut.
NOTE: The guiding edge fence of the workpiece must be straight for the cut to be straight. Use
caution to prevent the blade from binding in the cut.
OPTIONAL DUST EXTRACTION PORT
You have to use the dust extraction port before using the circular saw. The adaptor fits over the dust
chute which is located on the upper blade guard. The dust extraction port attaches to the adaptor.
NOTE: If you use the dust extraction port, you should always connect it to a standard vacuum hose
and wear a dust mask yourself.
To attach dust extraction port:
Remove the battery.
Lift lower blade guard.
Orient adaptor to fit into the dust chute opening on upper blade guard.
Secure adaptor with screw provided.
Align hole in the dust extraction port with raised lip on adaptor and snap into place when using a
vacuum hose.
CHANGING THE SAW BLADE
Always remove the battery pack before changing the saw blade !
1. Set the cutting depth (using the locking screw ) to the minimum position(0 mm).
2. Swing the blade guard back using the release lever and put the circular saw down.
3. Press the spindle lock button (until it engages) and use the hex key to release the Blade bolt .
Then remove the blade bolt and the outer flange.
4. Remove the saw blade .
5. Fitting a saw blade is carried out in the reverse order.
6. Press the spindle lock button (until it engages) and use the hex key to tighten the blade bolt
and the outer flange.
7. Ensure that the saw blade is suitable for the rotational speed of the tool.
FR FR
ES ES
PT PT
IT IT
EL EL
PL PL
RU RU
UA KZ
KZ UA
RO RO
BR BR
EN
EN
369