Using Test Leads - IDEAL 61-737 Operation And Safety Manual

400-amp ac clamp meter
Table of Contents

Advertisement

Available languages

Available languages

Using Test Leads

WARNING: Arc Flash and Shock Hazard, Proper PPE Required.
Follow all safety procedures, wear proper PPE in accordance to NFPA 70E and
follow the guidelines below and the instructions in this manual when operating
the meter with TL-757 Test Leads or equivalent. Test Leads must be rated for the
electrical environment the meter is being used in and have a voltage rating of at
least the voltage of the circuit to be measured. Failure to comply can result in
serious injury or death.
Choking Hazard, Small Parts. Keep Away from.Children. Sharp Objects
Hazard, This is not a toy. It is not for use or play by children. Keep Away
from Children. Failure to do so can result in serious injury.
Protective Cap
CAT III 1000V, CAT IV 600V (with cap on)
WARNING: To prevent possible electrical shock or personal injury, the
WARNING:
protective caps must be in place when operating a properly rated electrical meter/
1. Use only approved test leads. Do not use improvised connections that could
tester using the TL-757 Test Leads in a CAT IV 600V or CAT III 1000V environment.
present a safety hazard.
2. Never measure AC or DC current while the test leads are inserted into the input
jacks.
3. Prior to using the test leads, inspect them carefully for damaged insulation,
exposed metal or bent probes. Check test leads for continuity. Do not use leads
if they appear damaged.
4. When using the probes, keep fingers behind the finger guards on the probes.
5. Connect the common test lead before connecting the live test lead. When
disconnecting test leads, disconnect the live test lead first.
6. Always ensure that test leads are secured so that they cannot be accidentally
snagged or tripped over.
This meter is intended for use with the IDEAL TL-757 lead set (provided with this
product) or equivalent. The lead set must comply with requirements for Overvoltage
and Measurement Categories CAT IV 600V CAT III 1000V CAT II 1000V.
Guard Ring
M
No
Firs
NC
cor
freq
vol
and
The
slo
Plu
swi
the
con
NO
Wh
tha
en
CO
PP
wo
Vo
ma
12

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents