Troubleshooting - Vitek VT-1501 Manual Instruction

water supply off by setting the operation
mode switch (3) knob to the position « ».
Remove the tip (13) from the cappuccina-
10.
tor pipe (12) and put a suitable bowl under
the pipe (12). Wait until the indicator (2)
lights constantly, after that switch the steam
supply on approximately for 2 minutes by
setting the operation mode switch knob (3)
to the position «
steam supply off by setting the operation
mode switch knob (3) to the position « »
and switch the coffee maker off by setting
the power switch (14) to the position «0». Wait
for 10-15 minutes.
Repeat the procedure described in steps
11.
7-10 not less than 3 times.
Switch the coffee maker on by setting the
12.
power switch (14) button to the position «–»,
the indicator (1) will light up.
Wait until the indicator (2) lights constantly.
13.
With small intervals, repeat the boiler clean-
14.
ing procedure (clause 9) until the citric acid
solution dissolves in the tank (11) completely.
Fill the tank (11) with clear water up to the
15.
maximal mark, and repeat the clauses 7-10
not less than 3 times without the 10-15 min-
ute break.

Troubleshooting

Problem
The coffee maker
can't be switched on
Water leaks from
the lower part
of the coffee maker
Coffee leakage from
the filter holder
Ready coffee has
a foreign smell
Steam doesn't froth
milk
IM VT-1501.indd 7
», after that switch the
Cause
No voltage in the mains socket.
The power plug is not completely
inserted into the socket.
The water tray is full.
Loose connection of filter and
boiler gasket, ground coffee got
on the edges of the filter.
Wrong process of scale removal
in the coffee maker boiler
Improper storage of coffee
Low temperature of outgoing
steam
The tank is too big or of improper
size
You used skimmed milk
Switch the coffee maker on, setting the
16.
power switch (14) to the position «0».
Note:
To remove the scale you can use special
–
descaling agents for coffee makers and cof-
fee machines, strictly following the instruc-
tions on their usage.
CLEANING
If during the filter (4) cleaning you find out
–
that the openings are blocked with the
ground coffee remnants, you can clean them
with a small brush.
Clean the coffee maker body with a soft,
–
damp cloth and then wipe it dry. Do not use
metal brushes, abrasives and solvents.
Do not immerse the coffee maker body into
–
water or any other liquids.
Wash the removable parts of the coffee
–
maker with warm water and mild detergent,
then rinse them and dry.
Drip tray (9)
Remove the grid (8) from the tray (9), remove
–
the tray (9) and pour out water, wash the
tray (9) and put it back to its place, put the
grid (8) on the tray.
Solution
Make sure that the mains socket is
operating.
Check whether the plug is completely
inserted into the socket.
Pour the water out of the tray
Clean the edges of the filter.
See the chapters «Before using the
unit», «Descaling» and repeat them
several times.
Use fresh ground coffee. Keep coffee
in a dry cool place.
Froth milk only after the indicator (5)
lights up.
Use a narrow high container for
frothing milk
Use only whole milk with fat content
4-6%.
7
ENGLISH
20.05.2019 9:28:43