Eclipse GEO Operator's Manual page 4

KNOw YOUr gEO
BOlT assEMBlY
a EYE cOVEr scrEw
B EYE cOVEr
c sOlENOid assEMBlY
d pilOT ValVE
E circUiT BOard
F TriggEr
BaTTErY
OOps piN
OOps
iNsErT
OOps
6. BOdY
claMpiNg lEVEr
FEEdNEcK
B
a
c BlaNKiNg plUg
d
sOlENOid rETaiNiNg scrEws
E
F
MacrO liNE
ElBOw
OOps
KNOB
iNliNE rEgUlaTOr
assEMBlY
FraME
scrEw
OOps
scrEws
EclipsE shaFT 3 BarrEl
NOTE: the bore size of your shAft 3 mAy vAry
BOdY
AccordinG to the model of Geo you hAve.
your eclipse Geo comes as standard with a eclipse shaft 3 barrel.
the barrel screws into the body of the Geo using a right hand thread
meaning that if you hold the Geo pointing away from you the barrel screws
into the body in a counter-clockwise direction.
the barrel comprises of two parts, a barrel back
the two parts are joined together with a left hand thread meaning that
if you hold the barrel, with the back nearest you, the front unscrews in a
counter-clockwise direction. the bore size of the barrel back is engraved at
the end of the barrel back . c
on the barrel back there is a #016 nbr70 o-ring
from vibrating loose from the Geo body when the marker is fired. there is also
an o-ring on the barrel front E (#015 nbr70) helps with alignment between
the barrel back and front.
replace these o-rings as necessary.
d
c
a and a barrel front B .
d which prevents the barrel
E
a
NOTE: the Geo will only Accept cOcKEr ThrEadEd
bArrels. do not use Any other type of bArrel threAd.
QUicK gUidE
CONTENTS
ORIENTATION ORIENTATION
QUICK SET-UP
USING YOUR GEO
MENU TREE
ADVANCED SET-UP
MAINTENANCE
FAULT FINDING
B
SERVICE CENTERS
PARTS LIST
SPARES & ACCESSORIES
7.