Advertisement
Quick Links
Flat Panel Monitor
Rackmount
(TFT450R) Rack
Option Kit
Installation Card
Open Card Completely Before
Beginning Installation Procedures
RECYCLE SYMBOL
NOTICE
The information in this publication is subject to change without
notice.
COMPAQ COMPUTER CORPORATION SHALL NOT BE LIABLE FOR
TECHNICAL OR EDITORIAL ERRORS OR OMISSIONS CONTAINED
HEREIN, NOR FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES
RESULTING FROM THE FURNISHING, PERFORMANCE, OR USE OF THIS
MATERIAL. THIS INFORMATION IS PROVIDED " AS IS" AND COMPAQ
COMPUTER CORPORATION DISCLAIMS ANY WARRANTIES, EXPRESS,
IMPLIED OR STATUTORY AND EXPRESSLY DISCLAIMS THE IMPLIED
WARRANTIES OF MERCHANTABILITY, FITNESS FOR PARTICULAR
PURPOSE, GOOD TITLE AND AGAINST INFRINGEMENT.
This publication contains information protected by copyright. No
part of this publication may be photocopied or reproduced in any
form without prior written consent from Compaq Computer
Corporation.
© 1998 Compaq Computer Corporation
All rights reserved. Printed in the U.S.A.
Compaq, Registered U.S. Patent and Trademark Office.
Flat Panel Monitor Rackmount (TFT450R) RACK OPTION KIT
First Edition (July 1998)
Part Number 332682-021
Compaq Computer Corporation
Advertisement
Related Manuals for Compaq TFT450R
Summary of Contents for Compaq TFT450R
- Page 1 HEREIN, NOR FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING FROM THE FURNISHING, PERFORMANCE, OR USE OF THIS MATERIAL. THIS INFORMATION IS PROVIDED “ AS IS” AND COMPAQ COMPUTER CORPORATION DISCLAIMS ANY WARRANTIES, EXPRESS, IMPLIED OR STATUTORY AND EXPRESSLY DISCLAIMS THE IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS FOR PARTICULAR PURPOSE, GOOD TITLE AND AGAINST INFRINGEMENT.
- Page 2 The retractable tray assembly occupies 2Us of Compaq rack Step 1 space and can be used with all Compaq Rack Series products. From the printed report generated by the Rack Builder software, The fixed mounting bracket assembly occupies 8Us of Compaq...
- Page 3 Step 5 CAUTION: To reduce the risk of damage to the monitor, be sure that it remains stable at all times. Place the retractable tray assembly on the edge of a flat surface, then tilt the monitor up. Check to be sure that the monitor power cord and monitor signal cable are properly seated in the plastic guides on the rear of the monitor.
- Page 4 Tilt it back so that it lays flat in the retractable tray. 3. Fully extend the tray at the front of the rack and firmly hold the TFT450R while pushing in on the metal release levers Slide the tray into the rack until the latch is engaged.
- Page 5 Step 2 Turn the tray over and lay it on the edge of a flat, non-abrasive, unobstructed surface. CAUTION: To reduce the risk of damage to the monitor, be sure that it remains stable at all times. Tilt the monitor out and remove the four screws securing the bracket to the monitor.
- Page 6 CAUTION: To reduce the risk of damage to the moniotr, do not attempt to move it until these 4 screws are in place. Step 5 Place the fixed bracket on top of the monitor and secure it with the four screws retained from Step 2. Be sure that the monitor signal cable and AC Power cord are plugged into the monitor.
- Page 7 Step 7 Hold the monitor with bracket at a slight angle. Move the monitor into the rack. Pull the monitor forward and align the holes with the markings on the rack. Secure with four M6 screws. Place the AC adapter on the onto the power supply tray. Step 8 Move the faceplate into position over the cage nuts and secure with four M6 screws.