6275/6275i (RM-154)
RF Description and Troubleshooting
AMPS Tx Setup
Use the following procedures to prepare for AMPS Tx troubleshooting using Phoenix.
Note the 6236i variant does not support AMPS.
1. Connect the RF test connector to a spectrum analyzer.
2. Connect the mobile terminal to the PC via a test jig. (The bottom connector is a
USB port.)
3. Connect a power supply to the mobile terminal.
4. Open the Troubleshooting menu, and click Phone Control. The Phone Control
dialog box appears.
5. Click the LOCAL button in the Phone State tab to put the mobile terminal into
Local Mode.
6. Open the Troubleshooting menu, point to AMPS, and click AMPS Control. The
AMPS Control dialog box appears.
Page 12
Figure 6: Phone Control dialog box
Company Confidential
Issue 1 - September 2006