Sony Party-shot IPT-DS1 Operating Instructions Manual page 49

 Place the plate on the base with the multi connector through the hole.
The Sony logos on the main unit and plate should read in the same direction
ˎ
when the plate is attached to the main body.
The plate and tilt arm have guide markers which should be aligned when
ˎ
attaching.
On the plate:
Position marker A (
On the tilt arm:
Position marker C ( )
When placing the plate on the tilt arm, align the marker A (
ˎ
with the marker C ( ) on the tilt arm.
 Slide the plate until the marker B ( ) on it is aligned with the marker C ( )
on the tilt arm.
Make sure that the plate is properly seated.
ˎ
The plate clicks into place when inserted to the correct position.
If it is slightly raised, remove it and repeat the above steps to attach it.
ˎ
), position marker B ( )
) on the plate
Position marker C ( )
Position marker A (
Position marker C ( )
Position marker B ( )
13-GB
)