Cleaning Method - Saniflow M02A-UL Installation And Operating Manual

CLEANING METHOD

• Disconnect the handryer from the mains supply.
• Remove the 2 lower holding screws from the cover using the special key.
• Remove the cover and place it carefully on a cloth avoiding scratches and
scrapes.
• Clean the dust from the surface and the parts of the main card of the
electronic circuit. To do this, use a soft brush.
• Use the same brush to clean the motor surface , the entrance inlet of the
volute, the air outlet and the air inlet grille.
• With a soft cloth, clean the surface of the IR sensor closure screen and
remove any dust covering on its surface.
• Open the volute removing the safety screw and folding the closure clips and
clean the turbine and heating element of dust. Close the volute again, putting
in the closure clips and tightening the safety screw.
• Clean the dust from the perimeter of the base, especially the upper section.
• Assemble the cover, place the lower screws and connect the dryer once
again.
• Start up the machine repeatedly in order to expel remains of dust after the
cleaning process.
CLEANING OF THE COVERS WITH CHROME AND GOLD FINISHINGS
Use only a damp cloth to clean the casings. Do not use acids, bleaches,
products with clohidres, abrasives products, etc.
Do not damage or force any part during the entire process.
- 4 -