Related Manuals for Saniflow M09A
Summary of Contents for Saniflow M09A
- Page 1 HAND DRYER MACHFLOW-UL COVER SPECIFICATION M09A STEEL WHITE EPOXY M09AC STAINLESS STEEL BRIGHT FINISH M09ACS STAINLESS STEEL SATIN FINISH...
- Page 2 MACHFLOW -UL: High speed airflow with minimum energy consumption - High speed motor, adjustable from 450 to 1300 W. - Maximum air velocity: 203 mph. - 250 W heating element. - Electronic infrared detection sensor; adjustable from 2” to 8”.
- Page 3 MAINTENANCE • This file contains the instructions and images that describe the replacement of the components of this hand dryer. • Consult security instructions before using the equipment.
- Page 4 SECURITY INSTRUCTIONS • All installations, maintenance, and repairs must be carried out by qualified technician. Saniflow advises: 1. Become familiar with the appliance and read the instructions carefully before use. 2. Disconnect the appliance before carrying out maintenance or repair.
-
Page 5: Table Of Contents
Welcome to the inside world of MACHFLOW-UL, we will show you how to change the main components of the hand dryer: 1.- The cover Page 6 2.- The motor Page 7-10 3.- How to adjust the airflow & distance detection Page 11 4.- The electronic board Page 12-15 5.- The heating element... -
Page 6: The Cover
To remove the cover: Step 1: Unscrew the screws from the cover (2 units) with The Machflow security key supplied. Step 2: Carefully, remove the cover from the base. Pay attention not to damage the led sensors. - Page 7 Universal brush motor (18.000-26.000 r.p.m) - Minimum energy consumption. - Ultra-fast drying time. - Minimum CO emissions. - Minimum noise pollution.
-
Page 8: The Motor
To remove the motor: Step 1: With the support of a screwdriver, remove 4 screws from the upper nozzle. Step 2: Take out the upper nozzle (if the nozzle is extremely fixed, it’s suitable to use a plain screwdriver to make this step easier, but taking care not to damage the plastic pieces). - Page 9 Step 3: Once we clearly see the motor, (it’s disconnect motor cables recommended to use pliers).
- Page 10 Step 4: Take out the motor for its replacement. Step 5: To install a new motor, follow the above steps in the other way around.
-
Page 11: How To Adjust The Airflow & Distance Detection
How to adjust the airflow & distance detection “on-site” The adjustment can be made by moving the respective cursors of the two linear potentiometers as shown in this figure... - Page 12 Electronic board (P.C.B Board) - Allow adjustment distance detection. - Allow adjustment motor power (rpm) The Machflow is assembled with the motor potentiometer set at maximum in both “distance detection” and “motor rpm”.
-
Page 13: The Electronic Board
To remove the electronic board: Step 1: Unscrew the supply cables of the electronic plate. Step 2: With the support of pliers, take out the bridles that hold the cables to the base. - Page 14 Step 3: With a plane screwdriver, take out the Nylon screw that fixes the electronic plate to the base. Step 4: Carefully remove the electronic plate, paying attention not to damage the cables.
- Page 15 Step 5: Once the electronic place is out of its housing, unscrew the motor cables (2) connected to the equipment wiring. Step 6: To install a new electronic plate, follow the above steps in the other way around.
- Page 16 Heating element...
-
Page 17: General Maintenance
GENERAL MAINTENANCE Preventative Maintenance - Cleaning Inspect units annually or bi-annually, depending on the working load of the dryer. Clean the active parts of the unit, like the motor, the heating element, the fan wheel and the electronic board, with a small soft brush.