Method Of Use; Preventative Maintenance And Cleaning - Saniflow M02A-UL Installation And Operating Manual

• To reach the terminal strip the protective top should be opened.
• Connect the cables from the mains and earth wire to their locations in the
terminal strip. Once the electrical connection has been made, close the
protective cover again.
• Fit the metallic cover into the base, placing it from top to bottom with a certain
inclinations. Make sure the upper rib has entered in their location in the base.
• Place the lower screws, tightening with the specially supplied key.

METHOD OF USE

M02A-UL and M03A-UL families of hand dryers operate by hand detection. To
achieve optimum drying of hands, it is advisable to rinse them well first,
eliminating any soap left on them. Then, once the dryer is working, place the
hands at the distance of approximately 2 3/8" - 2 3/4" (6 -7 cm) from the air
outlet and rub the hands together. The detection of the hands and the later
start-up of the appliance is based on the emission/reflection/reception of an IR
light beam, that comes from the sensors positioned close to the exit outlet area.
On removing the hands the appliance stops in 2 - 3
seconds.
The appliance includes a protection system against
continuous improper use
(it stops after 120 seconds of continuous use).
M02A-UL / M02AC-UL / M02ACS-UL models
These models of hand dryer has an automatic
temperature control system. It supplies the adequate
heating power from 4 possible levels according to the
value of room temperature.
These models detect the presence of fixed objects (as
fixed targets) and in this case it stops automatically after
4 - 5 seconds of starting operation.

PREVENTATIVE MAINTENANCE AND CLEANING

Correct cleaning of the unit will lengthen its working life considerably. When in use, the
machine will accumulate dust inside which should be cleaned out if used regulary, at
least once a year.
-3-