Medela Symphony PLUS Quick Start Instructions

Symphony PLUS Pumping Programs
For mothers of term and preterm infants.
Quick start instructions
The Symphony PLUS breast pump, with its research-based
pumping programs, has been specifically developed to support
mothers throughout their lactation journey, helping to initiate,
build and maintain an adequate milk production.
EFFICIENCY
1 The INITIATE program
Use the INITIATE program directly after birth:
Every 2-3 hours or 8 times a day
For up to five days, OR
Until you have expressed a minimum of 20 ml from both
breasts combined in 3 consecutive pumping sessions.
Once selected, the INITIATE program runs automatically
for 15 minutes, with several pauses. It is important to
complete the full program. At the end of the program
the display shows "Program complete".
The pump switches off automatically.
2 The MAINTAIN program
Use the MAINTAIN program after secretory activation
(milk coming in) if:
The INITIATE Program has been successfully used
as per above, OR
Breastfeeding has been established, OR
You are more than five days post birth.
Continue pumping until the breasts feel well drained
and soft all over. Switch the pump off manually when
the pumping session is finished. On average, pumping
sessions last approximately 15 minutes.
Note: These quick instructions do not replace the
regular Instructions for Use. Please refer to Symphony
!
Instructions for Use for more detailed information.
Manufactured by Medela AG, Lättichstrasse 4b, 6341 Baar, Switzerland, www.medela.com.
Distributed by Medela Canada Inc. 4160 Sladeview Crescent, Unit #8. Mississauga, Ontario. L5L 0A1
Phone: 1 800 435 8316 info@medela.ca www.medela.ca
Double-pumping is recommended, as this can help to increase
and maintain milk production.
Symphony PLUS contains two pumping programs:
1
The INITIATE program
initiate milk production. The program mimics the irregular
and more rapid sucking and pausing pattern of a new born
infant in the first days of lactation.
2 The MAINTAIN program
an adequate milk production and optimize milk output after
secretory activation (milk coming in) has occurred.
The program, with its 2-Phase Expression technology, mimics
an infant's sucking pattern during established lactation.
1
INITIATE
INITIATE press
To select the Initiate Program,
press the let-down button
within 10 seconds of turning
the pump on. Sit back and
relax as the program will
turn off automatically after
15 minutes.
supports mothers to successfully
is designed to build and maintain
2
MAINTAIN
Press the Power button
to switch on the
Press power
breast pump.
The stimulation
phase begins.
The breast pump
MAINTAIN running
will automatically
change to the
expression phase
after two minutes.
If your milk starts to
flow before the end
of the 2 minutes, press
the let-down button
to change to the
expression phase.
Rotate the dial to the right to increase
vacuum until you experience slight
discomfort, then rotate to the left
to reduce the vacuum to your
maximum comfortable
vacuum level.
Français