Programmed Heating; Programming Number/Memory Pads - Panasonic NE-1252 Operating Instructions Manual

PROGRAM MEMORY
Model No. NE-1772 (1300 memory): 1 digit input = 0 to 9, 2 digit input = 00 to 99, 3 digit input = 000 to 999 and A00 to C99
Other models (30 memory):
To change the number of memory digits:
1. Press "Start" + "0" while the door is open.
2. Press the number of digits you want to set. (1 digit=1, 2 digits=2, 3 digits=3)
3. Press "Prog".
Note: The Digital Display Window illustration here is Model No. NE-1772.
The Digital Display Window differs for other models.
B. PROGRAMMED HEATING
X In Program Unlock Mode:
Example: To select Number/Memory pads "1" and "3" at A side in which your desired heating program
(at HIGH power for 3 min., single stage heating) is set
PAD
1
Place food inside the oven and close the door.
The oven lamp will turn on and "0" will appear.
Note: While "0" appears, operation is available. 1 minute after the door is
2
Press Shift (A/B/C) pad, the desired Number/Memory pads "1" and
"3".
The currently programmed information will be indicated.
Note: All models except Model No. NE-1772 display the memory number
3
Press Start pad.
The oven lamp will turn on and heating will start. The heating time will
count down.
• When all time expires, beep tone will sound and heating will stop. The oven lamp will turn
off. "0000" will blink until the door is opened. 1 minute later, cooling fan will stop.
• Open the door and take the food out. The oven lamp will turn on.
• Close the door. The oven lamp will turn off. 1 minute later, Digital Display Window will go
blank.
X In Program Lock Mode:
Just press the desired Number/Memory pad. Heating will automatically start without pressing Start pad. (See page 13)
 For Double (or Triple) Quantity heating:
Press Double (or Triple) Quantity pad before pressing the desired Number/Memory pad.
C. PROGRAMMING NUMBER/MEMORY PADS — single stage heating —
THE OVEN CAN NOT BE PROGRAMMED WHEN PROGRAM LOCk IS ACTIVATED! (See pages 13-14)
Example: To program cooking at DEFROST power for 1 minute into Number/Memory pads "1" and "5" at A side
PAD
1
Open the door and leave it open.
The oven lamp will turn on, and "0" will appear.
2
Press Prog pad.
"PROG" will start to blink.
How to Operate
A0 to C9 *For only A0 through A9 settings, you do not need to press Shift (A/B/C) pad.
INSTRUCTION
closed, "0" will disappear.
and time.
INSTRUCTION
- 11 -
DIGITAL DISPLAY WINDOW
DIGITAL DISPLAY WINDOW
Continue