Table of Contents
Advertisement
Backplane 12V and 5V 8-pin Power Connectors
JHDD_PWR0 and JHDD_PWR1 are 4-pin 12V and 5V DC power inputs for the system's
backplane. Refer to the table below for pin definitions.
TPM Header/Port 80 Connector
The JTPM1 header is used to connect a Trusted Platform Module (TPM), which is available from
a third-party vendor. A TPM is a security device that supports encryption and authentication in
hard drives. It enables the motherboard to deny access if the TPM associated with the hard
drive is not installed in the system.
Please go to the following link for more information on TPM:
manuals/other/TPM.pdf.
SATA Ports
The H12DGO-6 supports four SATA 3.0 ports through CN9 port and HDD backplane board
BPN-NVMe4-F418-B6S6 with a specific cable.
NVM Express Connections
Two NVM Express ports are located on the serverboard (from CPU2). These ports provide
high-speed, low-latency PCIe 4.0 x4 connections directly from the CPU to NVMe Solid State
Drives (SSD). This greatly increases SSD data-throughput performance and significantly
reduces PCIe latency by simplifying driver/software requirements resulted from direct PCIe
interface from the CPU to the NVMe SSD drives.
Backplane 8-pin Power
Pin Definitions
Pin#
Definition
Pin#
1
Ground
3
2
Ground
4
Trusted Platform Module Header
Pin Definitions
Pin#
Definition
Pin#
1
LCLK
2
3
LFRAME#
4
5
LRESET#
6
7
LAD3
8
9
3.3V
10
11
LAD0
12
13
NC
14
15
3.3V_STBY
16
17
GND
18
19
NC
20
63
Chapter 4: Motherboard Connections
Definition
+5V
+12V
http://www.supermicro.com/
Definition
GND
NC
LAD2
LAD1
GND
NC
SERIRQ
NC
NC
Advertisement
Table of Contents
