Assembly Diagram - HAMPTON BAY 518-132 Manual

Brushed nickel finish, chrome finish

Hide thumbs

Table Of Contents

Table of Contents

Available languages

second person to help support the weight of the fixture from below while the wiring connections are

being made). Feed the wire and ground wire through the hole in the center of the mounting strap and

rotate the threaded nipple, canopy loop and preassembled fixture clockwise until the threaded nipple is

secure in the mounting strap. Make sure the fixture cable and ground wires are not twisted during this

process.

8. Wrap the ground wire under and around the ground screw which is marked "GND", and fasten the

ground screw to make sure the ground wire is securely connected.

9. Make the ELECTRICAL CONNECTIONS (Required Supply Circuit: 120V, 60Hz):

a. Connect the negative (raised ribs without writing) wire from the fixture to the negative wire from

the Outlet Box.

b. Connect the positive (smooth with writing) wire from the fixture to the positive wire from the

Outlet Box.

c. Connect the ground (bare) wire from the fixture to the ground wire from the Outlet Box.

d. Secure the connections using the wire connectors. Wrap the wire connections with electrical

tape to secure the connections.

e. Position the wires back inside the outlet box.

Note: If you have electrical questions, consult your local electrical code for approved grounding methods

or obtain the services of a qualified, licensed electrician.

10. Slide the canopy back over the canopy loop and tighten to ceiling using the loop ring (Adjust the

length of the threaded nipple if necessary).

11. Check to make sure the canopy is held firmly against the ceiling.

12. Screw the bulb (not included) into the lamp-socket.

Caution: Refer to the re-lamping label near the lamp holder for recommended wattage.

13. Installation is complete. Turn on the power at the circuit breaker or fuse box.