Troubleshooting; Product Maintenance; Limited Warranty - HAMPTON BAY 518-132 Manual

TROUBLE SHOOTING:
Problem
Light bulb will
illuminate.
Fuse blows or
breaker trips when light
bulb is illuminated.

PRODUCT MAINTENANCE:

1. To clean the outside of the fixture, use a dry or slightly dampened clean cloth (use clean water,
never a solvent) to wipe the shade and surface of the fixture.
2. To clean the inside of the fixture, first disconnect power to the fixture by turning off the circuit
breaker or by removing the fuse at the fuse box. Use a dry or slightly dampened clean cloth (use
clean water, never use a solvent) to wipe the inside glass and interior surface of the fixture.
CAUTION: Do not use any cleaners with chemicals, solvents or harsh abrasives as damage to components
or finish may occur.
The manufacturer warrants this lighting fixture to be free from defects in materials and workmanship for a
period of five (5) years from date of purchase. This warranty applies only to the original consumer
purchaser and only to products used in normal use and service. If this product is found to be defective, the
manufacturer＇ s only obligation, and your exclusive remedy, is the repair or replacement of the product at
the manufacturer＇ s discretion, provided that the product has not been damaged through misuse, abuse,
accident, modifications, alterations, neglect or mishandling. This warranty shall not apply to any product
that is found to have been improperly installed, set-up, or used in any way not in accordance with the
instructions supplied with the product. This warranty shall not apply to a failure of the product as a result of
an accident, misuse, abuse, negligence, alteration, or faulty installation, or any other failure not relating to
faulty material or workmanship. This warranty shall not apply to the finish on any portion of the product,
such as surface and/or weathering, as this is considered normal wear and tear. The manufacturer does not
warrant and specially disclaims any warranty, whether express or implied, of fitness for a particular
purpose, other than the warranty contained herein. The manufacturer specifically disclaims any liability
and shall not be liable for any consequential or incidental loss or damage, including but not limited to any
labor / expense costs involved in the replacement or repair of said product.
Possible Cause
not 1. Light bulb is burned out.
2. Power is off.
3. Faulty wire connection.
4. Faulty switch.
circuit Crossed wires or power wire is
grounding out.

LIMITED WARRANTY

Corrective Action
1. Replace light bulb.
2. Make sure power supply is on.
3. Check wiring.
4. Test or replace switch.
Check wire connections.
4