Important Safety Instructions - HAMPTON BAY 518-132 Manual

Thank you for purchasing this Hampton Bay interior chandelier fixture. This product has been
manufactured with the highest standards of safety and quality.
FEATURES:
1. Uses 120 volt, 60 Watt MAX each, standard (A19) incandescent or candelabra (B10.5) light bulb(s)
(not included).
2. Standard 96 in wire and 72 in chain for open entry-way, dining room, and cathedral ceiling installations.
3. Can be used with any standard, 120 volt, incandescent style dimmer switch.
QUESTIONS, PROBLEMS, MISSING PARTS:
Before returning to your local Home Depot, please call our Customer Service Team at 1-877-527-0313 or
visit www.homedepot.com. Please reference SKU 518-132, UPC 008938601863 or SKU 526-920, UPC
008938601962.

IMPORTANT SAFETY INSTRUCTIONS

INSTALLATION INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY TO PERSONS
1. Read all instructions.
2. Do not install this lighting system in wet locations.
3. CAUTION - When the light is on, the lamp is HOT!
4. CAUTION - Hot surface. Keep away from curtains and other combustible materials.
5. Turn off/unplug and allow to cool before replacing bulb (lamp).
6. All electrical connections must be in accordance with local codes and the National Electrical Code. If
you are unfamiliar with methods of installing electrical wiring, secure the services of a qualified
licensed electrician.
7. This fixture is intended to be mounted to a 4in. square x 2-1/8in. deep metal octagon outlet box. The
box must be directly supported by the building structure.
8. Before starting the installation, disconnect the power by turning off the circuit breaker or by removing
the appropriate fuse at the fuse box. Turning the power off using the light switch is not sufficient to
prevent electrical shock.
TOOLS REQUIRED FOR ASSEMBLY & INSTALLATION (not included):
Bulb Safety Goggles
PARTS INCLUDED FOR ASSEMBLY (parts are not to scale):
(2)Outlet Box (3)Wire
Screws Connectors
1. Carefully unpack the fixture and lay out all of the parts on a clean surface.
2. First distribute the bent tubes from fixture to three or five parts equal separately.
3. Secure the column into the coupler and tighten in place.
4. Install the fabric shade on to the socket and tighten with the socket ring (preassembly on to the socket).
1. Make sure the electrical is power off, pull leads down out of junction box.
2. Adjust the length of the chain according to the desired height by removing unnecessary links.
3. Thread the fixture wire and the ground (bare) wire through the chain, feeding it through alternating
links, then through the canopy loop. Loosen the loop ring on the canopy loop and allow ring to slide
down over the chain.
4. Slide the canopy over the canopy loop and the chain (leave ring and canopy loose on chain at this time).
5. Insert and secure the threaded nipple into the canopy loop.
6. Attach the mounting strap to the outlet box using the two outlet box screws provided.
7. Raise the assembled fixture to allow for installation to junction box (it is highly recommended to use a
SAVE THESE INSTRUCTIONS
Ladder Gloves
Mounting Ceiling
bracket assembly canopy
FIXTURE BODY ASSEMBLY INSTRUCTIONS
CEILING ASSEMBLY INSTRUCTIONS
Wire Strippers Flathead
Screwdriver
Canopy Loop ring
loop
2
Phillips Electrical tape
Screwdriver
Fabric shade Socket ring