Advertisement
Available languages
Available languages
indoor unit, the indoor unit may beep twice as the unit is performing the initial automatic check.
received. Signals can be received up to approximately 7 meters (23 feet) in a direct line from the
lights and strong light can affect the ability of the indoor unit to receive signals.
Consult your dealer for service.
shocks. In addition, do not get the remote controller wet or leave it in a location with high humidity.
a wall and be sure to always place the remote controller in the holder after use.
mode setting to the AUTO (single set point) mode or AUTO (dual set point) mode.
For details, refer to the included Notice (A5 sheet) or the Installation Manual.
■
Press the [ON/OFF] button.
The ON/OFF lamp will light up in
green, and the operation will start.
6
1. Remove the top cover, insert two LR6 AA bat-
Top cover
2. Press the Reset button.
Power
Ref. Pipes
Indoor-Outdoor
Connection wire
Earth
teries, and then install the top cover.
1
2
3
Two LR6 AA batteries
Insert the negative (–) end of each
Press the Reset button with an
object that has a narrow end.
Press the [ON/OFF] button again.
The ON/OFF lamp will come off, and
the operation will stop.
Advertisement
