Table of Contents
Advertisement
Q To rear brake.
R Fasten the rear brake switch
lead with a band to down tube.
(four point)
S Cutting part at the edge of the
band.
T About 30_ X 45_
CABLE ROUTING
U Fasten the oil level sensor lead
with a locking tie to battery box.
Fix to the battery box with the
band. To fix, align the band to the
bottom of the box's hole while fix-
ing the lead to the back of the box
(inside the body). The cutting part
at the edge of the band comes to
the front side of the body.
–14–
SPEC
V Clamp the handlebar switch lead
(right) to the frame with a holder.
The part to open and shut is out-
side of the body.
W Arrange the throttle position sen-
sor connector, carburetor heater
connector and thermo switch
connector between the starting
circuit cut off relay and high ten-
sion code.
X Put the light reduce relay lead,
carburetor heater lead into the
bottom of the groove.
Hide quick links:
Advertisement
Table of Contents
