Yamaha XVS1100 2000 Supplementary Service Manual page 21

E Connect the purge hose (carbu-
retor side-solenoid valve side)
with joint, knob is out side of frame.
F Route the front turn signal / posi-
tion light lead and headlight lead
through the rear of headlight
body hole.
G Connect the ignition coil lead at
red tape to the right side.
H Knob of clip is rearside of body.
CABLE ROUTING
I Fasten the rear brake switch
lead to the rear brake switch
bracket with a plastic locking tie
and cut of the end, inside of frame.
J Fasten the wireharness, starter
motor positive (+) lead and bat-
tery negative (–) lead to the
frame with a plastic locking tie.
K From the engine.
L About 70 mm
–13–
SPEC
M Fasten the rear brake switch lead
and master cylinder reservoir
hose to the down tube with a plas-
tic locking tie, and cut the end of
locking tie and position is inside of
frame.
N About 20 mm (from bead end.
O Locate the band to forward of
down tube.
P Route the rectifire/regulator lead
and carburetor heater
through inside of battery box hole
to outside it and connect them.
lead