Yamaha XVS1100 2001 Supplementary Service Manual page 15

J Position the all connectors inside
of the connector cover.
K Through the wireharness of so-
lenoid valve between AIS duct
and fuel hose (for CAL).
L Fasten the alarm lead with a
plastic band on the LID.
M Fasten the sidestand switch lead
to the bracket of LID with plastic
locking tie.
N Fasten the lead with locking tie
near the side cover.
CABLE ROUTING
O Route the clutch cable through
the cable guide.
P Position the throtlle cable and
starter cable as shown and
clamp them with holder.
Q Fasten the handlebar switch
leads (left and right) under the
handle crown with a plastic
band. Set the band at four
notches and install it no slacking.
R Route the each hoses through the
frame guide and do not pinch it.
–7–
SPEC
S When installing the fitting plate,
do not pinch the each hoses and
wireharness.
T Wher install the AIS push the
wireharness to space of rearside.