Double Section Assembly; Piece Deflector Assembly; Ultra Rokite Shelves - Blodgett 1048 Installation Operation & Maintenance

Installation
Oven Assembly

DOUBLE SECTION ASSEMBLY

1. Fasten 12" (305 mm) legs to lower section.
2. Remove the sheet metal flue cover on bottom
of UPPER SECTION FLUE ONLY and save the
two screws.
3. Fasten crown angle leg frame to upper sec-
tions.
4. Insert double oven flue connector into upper
oven section flue until it is flush with the base
angle. Temporarily hold in place with tape.
5. Install upper section on bottom section.
6. Remove tape and slide flue connector into
position over the collar of the bottom section.
See Figure 2.
7. Fasten flue connector to bottom section with
screws from the flue cover.
8. Install drafthood or draft diverter with screws
provided.
Figure 2

3 PIECE DEFLECTOR ASSEMBLY

1. Deflectors are shipped in place in the oven. No
assembly is required.
2. Remove the shipping clip located in the back
center of each deflector before inserting two-
piece shelf assembly.

ULTRA ROKITE SHELVES

1. Slide one half of the Ultra Rokite shelf through
the door opening. Rest the shelf on the deflec-
tor and slide to the rear of the oven until it
drops into the shelf support. Slide the shelf to
the right.
2. Slide the other half of the Ultra Rokite shelf on
top of first shelf to the rear until it is within the
shelf support. Slide it all the way to the left until
it drops down into place.
3. Slide both shelf halves inward so the center
joint closes.
4. Refer to pre-heating instructions supplied with
Ultra Rokite.
NOTE: Because of the weight of the Ultra Rokite
shelves, take care to avoid injury to your-
self or damage to the shelves when sliding
sections into the oven. Use of 1" x 4"
pieces of lumber will help to slide shelves
into place.
6
Figure 3