Technical Data; Warranty - GreenWorks GD48LM51SP Operator's Manual

EN
Problem
The machine does not start.
The machine cuts grass unevenly.
The machine does not mulch correctly.
The machine is hard to push.
There is a high vibration in the machine.
The machine stops during mowing.
* If you cannot find the solution to these problems, go to the service center.
7

TECHNICAL DATA

Voltage
No load speed
Cut width
Cut height
Self-propelled speed
Grass catcher capacity
Weight (without battery
pack)
Measured sound pressure
level
Guaranteed sound power lev-
el
Vibration
Battery model
English
Possible cause
The battery capacity is low.
The bail switch is defective.
The safety key is not put in.
The lawn is rough.
The blade height is not set correctly.
Wet grass clippings attach to the deck.
The mulch plug is missing.
The grass is too tall, or the blade height
is too low.
The grass catcher and the blade drags in
thick grass.
The blade is unbalanced and worn.
The motor shaft is bent.
The blade height is too low.
The battery pack is out of power.
The grass clippings attach to the deck or
the blade.
Operation temperature of the machine is
too high.
48 V
2800 / min
510 mm
25 - 80 mm
0.6-1.5 m/s
50 L
27.5 kg
L = 85 dB(A) , K = 3
PA
dB(A)
L = 96 dB(A)
WA.d
2 2
< 2.5 m/s , K = 1.5 m/s
G4824B2/G4824B4 and oth-
er BAM series
Solution
Charge the battery pack.
Replace the bail switch.
Put in the safety key.
Examine the mowing area.
Adjust the blade/cutting height to a high-
er position.
Wait until the grass dries before mowing.
Install the mulch plug.
Increase the blade/cutting height.
Empty the grass clippings from the grass
catcher.
Replace the blade.
1. Stop the motor.
2. Remove the safety key and battery
pack.
3. Inspect for damage.
4. Repair the machine before you start
it again.
Increase the blade/cutting height.
Charge the battery pack.
Remove the battery pack and check the
deck.
Cool the machine.
Charger model
Double-insulated construc-
tion
IPX
8

WARRANTY

(The full warranty terms and conditions can be found on
Greenworks webpage)
The Greenworks warranty is 3 years on the product, and 2
years on batteries (consumer/private usage) from the date of
purchase. This warranty covers manufacturing faults. A faulty
product under warranty might be either repaired or replaced.
A unit that has been misused or used in other ways then
described in the owner's manual might be rejected for
warranty. Normal wear, and wear parts are not considered as
warranty. The original manufacturer warranty is not affected
by any additional warranty offered by a dealer or retailer.
8
G4824C4 and other CAM
series
IPX4