Yamaha YFM250XN 2001 Supplementary Service Manual page 19

1 Wire harness
2 Starter motor lead
3 Rear brake cable
4 Throttle cable
5 Starter relay
6 Rectifier/regulator
7 CDI unit
8 Starting circuit cut-off relay
9 Rear brake breather hose
0 Carburetor air vent hose
A Final gear case breather hose
B Taillight lead
CABLE ROUTING
Å Fasten the wire harness to the frame with the plastic clamps.
ı Make sure the starter motor lead and wire harness do not contact the
ignition coil.
Ç Fasten the wire harness, starter motor lead, and ignition coil lead to
the frame with the plastic locking tie.
Î Fasten the wire harness and starter motor lead to the frame with the
plastic locking tie.
‰ Install the starter relay onto the tabs with its terminal side facing up.
– 12 –
SPEC