Yamaha YFM250XN 2001 Supplementary Service Manual page 16

Ç Make sure that the starter motor lead is not
slacked.
Î Fasten the starter motor lead and wire harness
to the frame with the plastic band.
‰ Fasten the starter motor lead and wire harness
to the frame with the plastic clamp.
Ï Route the starter motor lead, wire harness, and
battery - lead through the hole in the rear
fender.
Ì Fasten the taillight lead and wire harness to the
frame with the plastic clamp.
CABLE ROUTING
Ó Fasten the taillight lead to the box with the plas-
tic clamp.
È Route the carburetor overflow hose between the
engine and upper rear engine mount and then
between the engine and swingarm. Make sure
that the hose is not pinched.
Ô Bend the cable guide after routing the cables.
Fasten the starter motor lead to the frame with
the plastic clamp. Route the starter motor lead
over the throttle cable and rear brake cable.
– 9 –
SPEC