STI J1210VA500 Installation & User Manual

Door handle cup protector

Door Handle Cup Protector Installation/User's Manual

・Read the "Cautions for Handling" carefully before using the product and use the product properly.

The important points are displayed with the following labels. Please follow the instructions by all means.

Instructions you must follow for your safety.

Warning

[When mishandled, it may cause death or serious injuries.]

Instructions to follow for safety and to protect your car.

Caution

[When mishandled, there is a danger that it may lead to injuries or an accident.]

Points you need to know

Advice

Handy points to keep in mind

・Never alter / modify the product.

・Doing so may damage the product and cause a serious damage.

・Be sure to stop the engine when working with the product to secure safety.

・Install the product securely.

・Do not use the product on vehicle types other than the applicable ones and for other than the

intended purpose.

Warning

Caution

Table of Contents

Need help?

Do you have a question about the J1210VA500 and is the answer not in the manual?

Page 1 Door Handle Cup Protector Installation/User’s Manual ・Read the “Cautions for Handling” carefully before using the product and use the product properly. The important points are displayed with the following labels. Please follow the instructions by all means. Instructions you must follow for your safety. Warning [When mishandled, it may cause death or serious injuries.] Instructions to follow for safety and to protect your car.
Page 3 4. Installed view ① Door Handle Cup protector 5. Installation main points ★This document demonstrates the left front side. Perform the work on the other doors similarly. ★Read this document completely to the end and perform the work when you understand the overall work procedure.
Page 4 (1) Preparation - continued (Figure 4) Clean/Degrease 1) Degrease / clean the door handle cup surfaces with rubbing alcohol and confirm that there is not residue. 2) Check that the temperature is 15℃ or higher (both vehicle body and the product). If less than 15℃, warm the vehicle body and the product to Figure 4 25 - 50℃...

J1210fl500J1210ca500J1210sj500