Replacing The Motherboard; Motherboard Shield And Cable Socket Locations - Commodore Amiga CD32 User Manual

Replacing the Motherboard
2-3
Shield Screws (3)
rum
m
9
T o T
0 O • O O o ~ o
o o o o o
o v o
- o
o ü o ü o
O O O O ^ O '
TTL
Q
TI
• o
o
--- ■ > . 'S ' >•
-0
-x •
• O;
% ■
° o
° o
0 b;0 S 0 o 0 o 0 o 0 ö ° o ° -
o n o o o o n ° • ° 0 :
. -*: V •* > :
u
^•sv~ .
%
•• -i • ' j-*
3
. '[ W >
i l
1 0
B
9
~TöT
--------------- 1 -----------------------------i---------------------
LEO Cable Socket LED Wire Tab CO Orive Cable Socket
1 3
Figure 2-2. Motherboard Shield and Cable Socket Locations
8. Remove the CD drive cable from the motherboard. Locate the CD drive cable socket on the
motherboard in Figure 2*2. The socket may be an insertion socket or a ZIF socket. Grasp
the cable firmly and pull it out of the socket. To insert the cable into an insertion socket,
grasp the flat ribbon cable and push it straight into the socket. To insert the cable into a
ZIF socket, first grasp the socket on its outside edges with a needle-nose pliers and pull the
socket up to release it. Then grasp the flat ribbon cable and push it straight into the socket.
Push the socket down to lock the cable in place.
9. Reverse this procedure to reassemble the top and bottom cases.
Replacing the Motherboard
Follow the instructions for removing the System top case on page 2-1.
To remove and replace the motherboard:
1. Locate the three shield screws on Figure 2-2 and remove the screws.
2. Lift the shield out of the case.