Replacing Field Replaceable Units (Frus); Replacing The Power Supply And Game Controller; Separating And Connecting The System Top And Bottom Cases - Commodore Amiga CD32 User Manual

Chapter 2
Replacing Field Replaceable Units
(FRUs)
This chapter gives instructions for removing and replacing the following FRUs:
• Power supply (part number 313375-01 to 313375-06)
• Game Controller (part number 365183-01
• System motherboard (part number 365101-02 PAL or 365101-01 NTSC)
• Bottom Case Assembly (part number 365159-01, see Chapter 5 for individual part numbers)
• CD drive cable (part number 313376-01)
• CD drive assembly (part number 365161-01
• LED cable (part number 365367-01)
• LED board assembly (pari number 365168-01)
• Top Case Assembly (part number 365160-01, see Chapter 5 for individual part numbers)
Order replacements according to the procedures established by your Service Organization.
Replacing the Power Supply and Game Controller
If the power supply or game Controller is defective replace it with a new item.
Separating and Connecting the System Top and
Bottom Cases
To remove the System top case:
1. Tum off the power switch and remove all connecting cables.
2. Remove the System case screws. Remove the case screw on the rear panel as illustrated in
Figure 1-2. Tum the System over and remove the five screws on the bottom of the case.
3. Tum the System over while holding the System bottom case firmly to the System top case.