Installing Backrest/Headrest; Removing Backrest/Headrest - Safety 1st Pronto Instructions Manual

Installing Backrest/Headrest

11
1
2
3
Locate the Backrest
Opening in Seat Base
Hold down the rectangular
shaped flap at the rear of the
seat base pad to fully reveal the
backrest opening.
Attach Backrest to Seat
Base
With the backrest laying flat
(horizontal), insert the backrest
hook into the backrest opening
at the rear of the seat base.
Make sure the seat base pad
does not get caught between
the moving parts.
The backrest may not connect
properly if the pad is in the way.
Rotate Backrest Up
Rotate backrest all the way up
into the locked position. In the
locked position, the backrest
will remain upright.
Tuck flap on seat base pad
under backrest pad.

Removing Backrest/Headrest

1
Lay Backrest Flat
To remove backrest/headrest
from seat base, backrest needs
to be in the most upright position.
See page 14.
Press firmly on backrest release
tab
it lays flat (2).
2
Remove Backrest/
Headrest
Lift backrest hook out of
opening in seat base.
Lay flap on seat base pad
over backrest opening.
Store backrest/headrest for
future use.
To remove headrest from backrest, see page 5.
12
(1) and rotate seat back until