Ventum NS1 User Manual page 8

SEAT POST INSTALLATION
1. Plug Di2 cable into seat post battery, you should hear a click.
2. Insert the seat post into the frame. Ensure the minimum insertion depth
of 10 cm is achieved.
3. Torque the seat post clamp bolt to a minimum of 8 N.m. Temperature,
moisture, and contaminants can affect the seat post clamp. If necessary,
it can be torqued up to 10 N.m.
NOTE: To remove or adjust the seat post, loosen the seat post clamp bolt.
It is not necessary to remove it from the clamp entirely. Simultaneously
tap the tail and nose of the saddle with your hands to disengage the
clamp's grip on the seat post and permit adjustment. Push or pull the
seat post as required to achieve the desired saddle height.
WARNING
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD LEAD TO SERIOUS INJURY OR DEATH.
14
STEP 1
SEAT POST INSTALLATION
STEP 3
15