Set Leds - Alcatel OmniPCX Enterprise 4029 Manual

Chapter
1
Note: In the US, F1 and F2 keys are programmed by default:
•
F1 puts the current conversation on hold
•
F2 transfers the current call
Keys F1 and F2 allow to:
• Program the user's preferred functions as, e.g. forwarding assistant call, headset,
specific call number
• Access them rapidly
1.2.4

Set LEDs

The Alcatel 4029/4039 set LEDs consist of:
- An alarm LED (see
- A message LED (located on the message key)
- A mute LED (located on the mute key)
- A hands-free LED (located on the hands-free key)
- F1 and F2 LEDs (located on the corresponding F1 and F2 keys)
When the set binary files are being downloaded, the alarm, message and hands-free LEDs
flash until initialization is over.
When the set is in operation, individual LED behavior is detailed in the following paragraphs.
1.2.4.1 Alarm LED
The alarm LED signals ringing and alarms.
LED Color
Green
Orange
Red
1.2.4.2 Message LED
The behavior of the message LED is determined by the Message LED configuration
parameter defined in the set class of service: IPTouch > IPTouch classes of service >
Phone COS.
When the attribute value is:
Blinking, on (default value)
1-6
figure: Alcatel 4039 Set Layout
Signals
Internal incoming call
External incoming call
-
-
-
Then:
When at least a message (alarm, voice, text, callback,
unanswered call) has not been heard/viewed, the LED
blinks red.
After message consultation, the Message LED is lit red.
If there is no message left in the message memory, the
Message LED is off.
or figure: Alcatel 4029 Set Layout
Manager call (in an Assistant/Manager
configuration)
Priority call
Alarm call
)