Fujitsu ETERNUS LT20 S2 User Manual page 38

Chapter 3 Setting the Operating System
3.1 Solaris OS
3.1.3.2 Getting the Server to Recognize the Device
(1) Check the settings.
Add the descriptions of the device to the st driver setting file (/kernel/drv/st.conf) by using a text editor
(such as vi).
• Example
#
# Copyright 2004 Sun Microsystems, Inc.
# Use is subject to license terms.
#
#
#pragma ident
#
name="st" class="scsi" target=0 lun=0;
name="st" class="scsi" target=1 lun=0;
name="st" class="scsi" target=2 lun=0;
name="st" class="scsi" target=3 lun=0;
name="st" class="scsi" target=4 lun=0;
name="st" class="scsi" target=5 lun=0;
name="st" class="scsi" target=6 lun=0;
#
# In case there are wide tape drives, one can use these targets
#
#name="st" class="scsi" target=8 lun=0;
#name="st" class="scsi" target=9 lun=0;
#name="st" class="scsi" target=10 lun=0;
#name="st" class="scsi" target=11 lun=0;
#name="st" class="scsi" target=12 lun=0;
#name="st" class="scsi" target=13 lun=0;
#name="st" class="scsi" target=14 lun=0;
#name="st" class="scsi" target=15 lun=0;
# This line adds support for Fibre Channel Tapes
name="st" parent="fp" target=0;
- FC-AL connection
For "target=", specify the Loop-ID that is set in the LT20 S2/LT40 S2/LT60 S2.
- Fabric connection (for SE0X7F11X or SE0X7F12X only)
For "target=", specify the target ID of the "fcp-bind-target" parameter that is described in the setting file
of the HBA device driver (/kernel/drv/fjpfca.conf).
The setting file does not need to be edited for SE0X7F21X, SE0X7F22X, SE0X7F31X, or SE0X7F32X.
(2) Restart the server.
Reconfigure and restart the server to make the server recognize the registered device. Execute the
following command:
# touch /reconfigure
# /usr/sbin/shutdown -y -g0 -i6
FUJITSU Storage ETERNUS LT20 S2/LT40 S2/LT60 S2 Tape Library User's Guide -Server Connection-
All rights reserved.
"@(#)st.conf 1.34 04/06/24 SMI"
38
Copyright 2021 FUJITSU LIMITED P3AM-5322-12ENZ0