Table of Contents
Advertisement
NOTE
Port 0 is the QFO-C access module itself.
Changing the Port Service State
From the Service State Screen, type the desired port
number and press Enter. The Port Service Status
Screen (Figure 9) will appear.
Shelf:
Unacknowledged Alarms:
Shelf:
Unacknowledged Alarms:
14
Slot:
10
Total Access System
Port 1: Out of Service - Unassigned
1.
In Service
2.
Out of Service - Unassigned
3.
Out of Service - Maintenance
Selection:
'?' - System Help Screen
Figure 9. Port Service Status Screen
Slot:
10
Total Access System
Provisioning for All Ports
1.
DSX Equalization
2.
Loopback Timeout
3.
AIS to DSX (Loss of T1)
4.
AIS to DSX (FLOS)
5.
Restore Factory Defaults
Selection:
'?' - System Help Screen
Figure 10. Provisioning of All Ports Screen
Section 61181300L1-5C, Issue 3
Type the number corresponding to the desired service
state. Press Enter.
From the Provisioning screen (Figure 7) type "2" and
press Enter to select All Provisioning. The
Provisioning of All Ports Screen (Figure 10) will
appear.
MINOR
MINOR
0 to 133' ABAM
120 Min.
Disabled
Disabled
07/15/99 10:42
07/15/99 10:45
61181300L1-5C
Advertisement
Table of Contents
