Using The Jenco Model 6309 Pot; Front Panel (Key Function Illustration) - JENCO 6309 POT Operation Manual

III. USING THE JENCO MODEL 6309 POT
A. FRONT PANEL
1. The [MODE/-] MODE or CURSOR key.
1a. In Normal mode this key will change the ORP display to
ORP ABS(olute) or ORP REL(ative).
1b. In Calibration/ Setting mode this key will move to the
next digit of the current active parameter.
1c. In Calibration/ Setting mode, pressing this key for two
seconds will move you back to the previous parameter.
2. The [CAL / VIEW] key.
2a. Pressing this key for about two seconds, during main
display mode will switch to Calibration/Setting mode.
2b. During Calibration/Setting mode this key will switch to the
next available Calibration/Setting page. Pressing this key at
TEMP. CONTROL SETTING will place the display back to
the MAIN DISPLAY MODE.
6309POT
JENCO
CAL.
MODE
VIEW
CURSOR
pH RECAL.
5