Table of Contents
Advertisement
2. At MAIN DISPLAY pressing the [MODE/-] key will toggle
between ABSolute ORP and RELative ORP.
3. You can change any blinking options or digit by pressing the
[
] or [
] keys.
4. For options in digit format you need to press the [MODE/-]
key to move the cursor to the next digit .
5. If you are satisfied with the selection you made you need to
press the [
next option.
6. If you don't need to change the current blinking option just press
the [
] ENTER key to move to the next selection.
7. You also can press and hold [MODE/-] key for two seconds and
will move back the cursor to the previous option.
a. CHECK PASSWORD
Calibration/Setting mode if the system is password locked by just
pressing the [CAL/VIEW] key on this page. If the unit is
"PASSWORD LOCKED" going to Calibration/Setting mode will
not affect the function of the relays and analog output.
CAUTION: If the unit is not locked then every time the user enters
the Calibration/Setting mode the relays and analog out will be
frozen.
] ENTER key to save the changes and move to the
You will only see this page if the
unit is password locked. To change
any settings or calibration you need
to unlock the system to remove the
"PASSWORD LOCKED" message.
You need to enter the correct four
digit
number
PASSWORD" input. You can still
view
all
13
on
the
"ENTER
the
pages
of
Advertisement
Table of Contents
