Table of Contents
Advertisement
53963-gb.fm5 Page 16 Tuesday, March 13, 2001 7:28 PM
Technical information for the installer
OVEN
•
After removing the oven from its packaging, before
making the connections place it on the polystyrene
foam base to protect it from damage.
•
Do not attempt to lift the oven by the handle.
Lift at the sides as shown in the figure (see arrow).
•
Check that the appliance has not been damaged in
transit.
•
Oven dimensions and kitchen unit dimensions are
shown in the opposite figure.
•
Kitchen units in contact with the oven must be heat
resistant (80° C).
•
If plastic laminates or cement are not sufficiently
heat-resistant, warping, bubbling or detachment of
the finish may result.
•
For correct ventilation, follow the ventilation
opening directions shown in the figure (at least
500 x 80 mm). Also provide for at least 5 mm
clearance between the top of the oven and the
lower edge of the worktop. This space must not
be obstructed by cross rails or other structural
elements.
•
During oven installation, care must be taken to
ensure that the sides are not touching the front
edges of the housing or adjacent drawers and
doors (see picture).
•
Carry out the electrical connections between
cooktop and oven (see chapter "Electrical
connection").
•
Secure the oven to the kitchen unit with screws (A)
as shown.
16
INSTALLATION
No contacts
Advertisement
Table of Contents
