Table of Contents
Advertisement
53963-gb.fm5 Page 18 Tuesday, March 13, 2001 7:28 PM
•
Make sure the appliances are installed
and connected to the electricity supply by
a qualified technician in accordance with
the manufacturer's instructions and in
compliance with local regulations.
•
The installer is responsible for the correct
electrical connection of the appliances
and the observance of the relative safety
regulations.
Connecting the oven to the power supply
•
Make sure that the voltage shown on the rating
plate is the same as the power supply voltage in
your home. The rating plate is on the front edge of
the oven cavity (visible with oven door open).
•
Use a type H05RR-F power cord (minimum
length 800 mm).
•
Warning: All the oven's components operate at
230-240 V. When using a 400 V connection,
make sure that the voltage reaching the oven is
230-240 V, as illustrated in the side table.
Conductors X
number
~
1N+
~
2N+
~
3 +
~
3N+
Interconnecting cooktop and oven
•
Before connecting the oven to the power supply,
check that the cooktop is among the ones listed in
the cooktop/oven pairing product sheet.
Connect the 3 pole and 4 pole connectors to the
respective connectors on the oven.
•
The 3 pole connectors (H) is located at the rear
right hand side of the control panel, the 4 pole
connector (J) is located at the top of the oven in the
left hand corner (see figure).
•
Connect the yellow/green striped earth wire (
(K) from the cooktop to the screw located near the
3 pole connector.
WARNING: DO NOT CONNECT TO THE
POWER SUPPLY BEFORE YOU HAVE
FINISHED CONNECTING THE OVEN AND
COOKTOP.
•
Mount the oven in the kitchen unit.
Make sure the power cord is not trapped.
18
ELECTRICAL CONNECTION
•
•
•
•
Connection
H05 RR-F 3X4 mm²
H05 RR-F 4X2.5 mm²
H05 RR-F 4X2.5 mm²
H05 RR-F 5X1.5 mm²
)
The appliance must be connected to the
electricity supply by means of an all-pole
disconnect switch with minimum contact
gap of 3 mm.
The appliances must be earthed by law.
Do not use multiple plug adapters or
extension leads.
After the appliances have been installed,
the electrical components must be
inaccessible.
Advertisement
Table of Contents
