Table of Contents
Advertisement
Available languages
Available languages
Changing the default settings
A large number of default settings can be comfortably changed
via the screen menu.
Press the SETUP-button (Fig. 1/25) on the remote control to
start the menu for changing the default settings (only in DVD
mode).
NOTE:
•
Many of these default settings can be changed via both
the remote control and the menu. The difference is: If you
change the default settings via the remote control, these
changes will only be valid until the DVD-Player is switched
off or the DVD is changed.
•
However, any changes made in the menu are permanent.
Understanding the menu structure
The Setup menu has two menu levels:
•
Main menu: The main level is represented by graphical
symbols.
•
Sub-menu: The corresponding sub-menu options can be
found under each of the main menu options.
Using the menu
Navigation and selection
•
Use the Cursor Buttons (Fig. 1/14) ( , ) on the remote
control to browse through the main menu.
•
In contrast to this, you must use the Cursor Buttons ( ,
) to move in the sub-menu.
•
Select a menu option with the ENTER-button (Fig. 1/27).
•
Use the ENTER-button also to select an option (e.g. "PAL"
in the illustration on the top). The selected option (in the
example „NTSC") is now highlighted.
Slide control
In some menus you will fi nd slide controls. The slide control is
used as follows:
1. Select with the ENTER-button.
2. Move the control with the Cursor Buttons ( , ).
3. Confi rm the entry with the ENTER-button.
28
05-AR 737 DVD_GB 28
Overview of the main menu
•
General Settings (1)
•
Speaker Settings (2)
•
Digital Settings (3)
•
Preferred Settings (4)
NOTE:
Some of the menu settings can only be selected in stop mode
(depending on the DVD).
TV Display
Here you can adapt the output of the DVD-Player to the TV-aspect.
Concerning the background: If you do not have a wide screen
TV the TV-aspect will be 4:3. However, most feature fi lms
have an aspect of 16:9, the image is therefore too wide for the
TV-screen.
Here you can specify how the replay of the fi lm is to be adapted
to the replay device:
•
Norm/PS: You will only see the middle section of the fi lm.
The borders will be cut off („Pan-Scan").
•
Norm/LB: You will see the complete width of the fi lm. The
fi lm is thus reduced in size, whereby black bars appear
below and above the fi lm („Letter-Box").
•
Wide: Select this option if you use a wide screen TV for
replay. Please note that fi lms, that have been recorded with
TV-aspect 4:3 can still be replayed using aspect 4:3. This
means, that replaying this fi lm will not require the complete
wide screen area of the television.
General Settings
Angle Mark (Camera Angle)
If the DVD contains sequences recorded from different camera
angles you can use the ANGLE button (illustration 1/15) to
select the various camera angles. This function is only available
if the DVD contains scenes with various camera angles.
Before you can use this function it has to be activated.
•
On: The angle symbol is shown on the screen.
•
Off: No angle symbol is shown on the screen.
21.08.2006, 11:50:07 Uhr
Advertisement
Table of Contents
