livin flame Skomo User And Installation Instructions Manual page 62

The stove does not turn
on automatically
Lock the stove.
Pellets not being fed into
the combustion chamber
The stove runs for a few
minutes and then turn
off
Fume extraction fan does
not stop
28
1. The tank is empty.
2. The resistance does not reach the
temperature
3. Resistance damaged
4. The pellet drops
5. Screw motor defective
6. The grate is not in place or is dirty
7. Obstruction of nests or foreign
bodies in the chimney or fireplace
8. Check operation of the glow plug
9. The ash drawer is not closed
properly
10. Clogged flue and chimney
11. Smoke extractor not working
12. Temperature sensor defective
13. Pellet wet
1. The tank is empty
2. The cochlea is no pellet
3. Technical problem of the cochlea
4. Reduction motor failure
5. Electronic board faulty
1. Lighting cycle not completed
2. Temporary failure of electricity
3. Probes fumes defective or broken
or not inserted
1. The stove has not yet cooled
1. Fill the tank with pellets
2. Check the electrical wiring and fuses, replace if the
resistance is broken
3. Replace the resistance
4. It is recommended to unplug the power supply before:
- check that the pellet is not caught in the chute
- check that the cochlea is not blocked by dirt
- check the seal of the pellet-door
5. Contact an authorized service center
6. Check that the hole in the brazier matches the glow
plug, clean brazier
7. Remove any foreign body from the chimney or flue pipe
8. Make sure that there is power. Replace the spark plug
if burned
9. Close the drawer ashtray
10. Perform periodic cleaning
11. Check the operation of the extractor flue
12. Contact an authorized service center
13. Make sure the place of stowage pellet and replace it
with a handful of dry pellets
1. Load the pellets in the tank.
2. Fill the tank and proceed as instructed before ignition
stove
3. IT IS RECOMMENDED to unplug the power supply
before:
- empty the thank and manually free the auger from
obstructions (sawdust)
- release the slide from obstructions
- remove the dust accumulation of pellets in the bottom
of the tank
4. Replace the reduction motor
5. Replace the electronic board
1. Re-run power
2. Re-run power
3. Check and replace sensors
1. Allow the stove to cool. Only after cooling fan will stop.
If the problem persists, contact your authorized
service center