Operation - Makita M6600 Instruction Manual

Install the mixing blade on the top of shaft and secure it
with hex bolt.
► 1. Mixing blade 2. Shaft 3. Hex bolt
In case of mixing blade 150 (accessory), screw it
directly on the top of shaft as it is threaded.
Installing top grip (auxiliary handle)
Screw the top grip on the tool securely.
Installing back grip (country specific)
1
1
3
► 1. Leaf spring 2. Rear handle 3. Boss
Pull off the cap from the tool housing. Insert the leaf
springs into the groove of the handle part that has the
bosses. Then attach them to the bottom of the tool
housing.
1
2
► 1. Rear handle 2. Screw
3
Attach both of the handle parts and tighten them with
the screws securely.

OPERATION

CAUTION:
operate the tool around flammable materials such
as paint with thinner used as solvent. Failure to do
so may cause an injury.
CAUTION:
the mixing blade floating out of the material, be
careful not to splash the material.
1. Always use the top or back grip (auxiliary handle)
and firmly hold the tool by top or back grip and switch
handle during operations.
2.
Place the mixing blade under material fully and
turn on the tool after making sure work site safety.
3. Move the mixing blade up and down during the
mixing operation so that whole part of material can be
3
mixed.
2
4. When finishing mixing, turn off the tool, make sure
that the mixing blade has come to a complete stop, and
then pull it out of the mixing container.
6 ENGLISH
2
Do not mix flammable materials or
When you mix the material while
2
1