Operation; Maintenance; Replacing Filter; Optional Accessories - Makita UT1305 Instruction Manual

Installing the mixing blade
► Fig.6
To mount the mixing blade, install it with the " UP " mark
on it facing the tool (directing inside).
Install the mixing blade on the top of shaft and secure it
with hex bolt.
► Fig.7: 1. Mixing blade 2. Shaft 3. Hex bolt
In case of mixing blade 150 (accessory), screw it
directly on the top of shaft as it is threaded.

OPERATION

CAUTION:
Do not mix flammable materials or
operate the tool around flammable materials such
as paint with thinner used as solvent. Failure to do
so may cause an injury.
CAUTION:
When you mix the material while
the mixing blade floating out of the material, be
careful not to splash the material.
1. Hold the rear handle of the tool with one hand
and the grip with the other hand firmly, place the mixing
blade under material fully and turn on the tool after
making sure work site safety.
2. Move the mixing blade up and down during the
mixing operation so that whole part of material can be
mixed.
3. When finishing mixing, turn off the tool, make sure
that the mixing blade has come to a complete stop, and
then pull it out of the mixing container.

MAINTENANCE

CAUTION:
Always be sure that the tool is
switched off and unplugged before attempting to
perform inspection or maintenance.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.

Replacing filter

► Fig.8: 1. Filter 2. Cover 3. Screwdriver
Replace the filter regularly as the cooling efficiency of
the tool is reduced due to built-up dust or particles in
the filter.
Insert the slotted bit screwdriver and the like between
the tool and the cover as shown in the figure. Lift it up
just like using a shovel and remove the cover.
Replace the filter in the cover with a new one.
Reinstall the cover on the tool.
Replacing carbon brushes
► Fig.9: 1. Limit mark
Check the carbon brushes regularly.
Replace them when they wear down to the limit mark.
Keep the carbon brushes clean and free to slip in the
holders. Both carbon brushes should be replaced at the
same time. Use only identical carbon brushes.
1. Use a screwdriver to remove the brush holder
caps.
2. Take out the worn carbon brushes, insert the new
ones and secure the brush holder caps.
► Fig.10: 1. Brush holder cap
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
OPTIONAL
ACCESSORIES
CAUTION:
These accessories or attachments
are recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons. Only use accessory or attachment
for its stated purpose.
If you need any assistance for more details regard-
ing these accessories, ask your local Makita Service
Center.
• Mixing blade
Type
Mixing blade 130
Mixing blade 150
Mixing blade 165
• Shaft
NOTE: Some items in the list may be included in the
tool package as standard accessories. They may
differ from country to country.
6 ENGLISH
Maximum diameter Twin blade
possible
130 mm
150 mm
165 mm
-
-
-