Operation - Makita M6600X Instruction Manual

1
2
3
015024
Hold the shaft holder with the wrench and tighten the
hex nut with the other wrench in the direction of arrow.
Installing mixing blades (country specific)
007094
To mount the mixing blade, install it with the " UP " mark
on it facing the tool (directing inside).
007095
Install the mixing blade on the top of shaft and secure it
with hex bolt.
Installing top grip (auxiliary handle)
015027
Screw the top grip on the tool securely.
1. Wrench
2. Shaft holder
3. Wrench
1. Mixing blade
1
2. Shaft
3. Hex bolt
2
3
Installing back grip (country specific)
1
1
3
015028
Pull off the cap from the tool housing. Insert the leaf
springs into the groove of the handle part that has the
bosses. Then attach them to the bottom of the tool
housing.
2
015029
Attach both of the handle parts and tighten them with
the screws securely.

OPERATION

Mixing
CAUTION:
Do not use to mix flammable material such as
•
paint with thinner used as solvent. Failure to do so
may cause injury.
Mixing with the mixing blade floating out of the mixing
•
material may cause the material to splash about.
015026
1. Always use the top or back grip (auxiliary handle)
and firmly hold the tool by top or back grip and
switch handle during operations.
2. Place the mixing blade under material fully and
turn on the tool after making sure work site safety.
3. Move the mixing blade up and down during the
mixing operation so that whole part of material
can be mixed.
5
1. Leaf spring
2. Rear handle
3. Boss
3
2
1. Rear handle
2. Screw
2
1