To Install Directx 8.0A; If You Are Running Windows 2000; If You Are Running Windows Me - Sony DCR-IP5 MovieShaker v3.1 Operating Instructions Manual

To Install DirectX 8.0a

If your operating system is Windows 2000 or Windows Me, you need DirectX
8.0a or later. If DirectX 8.0a or later is not installed on your computer, you
need to install it in advance.
Insert the MovieShaker CD-ROM into the CD-ROM drive. Clicking "Install
MovieShaker" on the displayed screen (page 11) will display the screen
where you can select software to install. When you click "Install DirectX 8.0a"
on this screen, installation of DirectX 8.0a will start. Follow the instructions
on the screen to finish the installation.

If you are running Windows 2000

If your operating system is Windows 2000, you need to update Windows
2000.
Insert the MovieShaker CD-ROM into the CD-ROM drive. Clicking "Install
MovieShaker" on the displayed screen (page 11) will display the screen
where you can select software to install. When you click "Update Windows
2000" on this screen, the update of Windows 2000 will start. Follow the
instructions on the screen to finish updating.

If you are running Windows Me

If your operating system is Windows Me, you need to update Windows Me.
Insert the MovieShaker CD-ROM into the CD-ROM drive. Clicking "Install
MovieShaker" on the displayed screen (page 11) will display the screen
where you can select software to install. When you click "Update (1)
Windows Me" on this screen, the update of Windows Me will start. After
"Update (1) Windows Me" is finished, continue by clicking "Update (2)
Windows Me." Follow the instructions on the screen to finish updating.
Note
When you connect the MICROMV device to your computer for the first time,
depending on the computer configuration, the "Version Conflict" dialog (dialogue) box
may appear. When the dialog (dialogue) box appears, be sure to click "Yes."
17