Clamping Tool - Rehau RAUTOOL A-light Operating Instructions Manual

5. Insert joint fully into

clamping tool.

Caution!
Do not tilt. Tool must be
applied over full surface and
at right angles.
7. By actuation of the reset slide
(unique full pulling back) the tool
will automatically return to star-
ting position.
6. Initiate clamping process by
actuating the control switch and
clamp compression sleeve up to
the fitting collar.
Caution!
Do not touch moving parts (risk
of trapping fingers!)!
The clamping process may be
interrupted any time by releasing
the control switch.
27