Description Of The Led Display On The Tool - Rehau RAUTOOL A-light Operating Instructions Manual

Description of the LED display on the tool

In conjunction with the control electronics, the light diode display is
used for information on the charging status of the battery and the
tool.
SELF TEST!
BATTERY IS EMPTY!
MAINTENANCE!
MAINTENANCE!
BATTERY IS EMPTY!
When the battery is inserted, the light diode display flashes several times. This
indicates that the electronic control successfully carries out its self test.
Caution! Wait approx. 30 sec between the removal of the empty battery and the
insertion of the charged battery in order to carry out the self test.
If the light diode display steadily lights after an operation for approx. 20 sec., the
battery is discharged and must be re-charged. .
If the light diode display flashes always at the end of an operation for approx. 20 sec.,
maintenance is required (after 5000 joints). The device is to be sent to the
plant as soon as possible.
If the LED is illuminated for 20 sec and then flashes, maintenance is required and
the battery at the same time empty.
23